installation and configuration of cisco secure acs 5.3 (vmware) – part 3

Next part of the Secure ACS configuration in my case is the NTP server because it is important for logging.

The NTP server configuration is quite simple but the acs service of the server has to be restartet once a change is made.

When you login to the server via console of the VM or via SSH then you will notice that the look and feel is the same as when you configure a Cisco router or switch. Only difference is that a lot of commands are missing as they are not necessary for the Secure ACS.

Once you are logged on you can configure the NTP Server with the following steps:

Finally you can do a “copy run start” to save the config :).

Feel free to comment!
Regards!
Markus

Advertisements

About markus.wirth

Living near Limburg in Germany, working as a Network Engineer around Frankfurt am Main.
This entry was posted in Cisco Secure ACS 5.3 Installation & Configuration, Uncategorized and tagged , , , , , , , , , , , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s